Alpha Bridge AQSFP28-100G-LR1

Features

  • QSFP28 MSA-compliant
  • Support 125Gbaud
  • 100G Lambda MSA 100G-LR Specification compliant
  • Up to 10km transmission on single mode fiber(SMF) with FEC
  • Operating case temperature: 0 to 70oC
  • 4x25G electrical interface (OIF CEI-28G-VSR)
  • Maximum power consumption 4W
  • LC duplex connector
  • RoHS compliant

Application

  • Data Center Interconnect
  • 100G Ethernet
  • Enterprise networking

Description

This product is a transceiver module designed for 10km optical communication applications. The module incorporates one channel optical signal, on 1310nm center wavelength, operating at 50Gbaud data rate. The transmitter path incorporates an EML Driver integrated in the DSP and a cooled EML together. On the receiverpath, the input optical signal is coupled to a Pin photodiode detector. A DSP based gearbox is used to convert 4x25Gbps NRZ signals to 1x50Gbaud PAM4 signal. Also a 4-channel retimer and FEC block are integrated in this DSP. The electrical interface is compliant with IEEE 802.3cd and QSFP28 MSA in the transmitting and receiving directions, and optical interface is compliant to IEEE 802.3cd and 100G Lambda MSA with Duplex LCconnector. The module has a maximum power consumption of 4.0W. The product is designed with form factor, optical/electrical connection and digital diagnostic interface according to the QSFP28 Multi- Source Agreement (MSA). It has been designed to meet the harshest external operating conditions including temperature, humidity and EMI interference.

Absolute Maximum Ratings

Parameter Symbol Min. Typ. Max. Units Note
Storage Temperature Ts -40 85 ℃    
Operating Case Temperature TOP 0 70 ℃    
Supply Voltage VCC -0.5 3.6 V    
Relative Humidity (non-condensation) RH 0 85 %    

Recommended Operating Conditions

Parameter Symbol Min. Typ. Max. Units Note
Operating Case Temperature TOP 0   70 ℃  
Power Supply Voltage Vcc 3.135 3.3 3.465 V  
Data Rate, each Lane     25.78125   Gb/s  
Optical Data Rate (PAM4)     53.125   GBd  
Data Rate Accuracy   -100   100 Ppm  
Pre-FEC Bit Error Ratio       2.4x10-4    
Post-FEC Bit Error Ratio       1x10-12   1
Control Input Voltage High   2   Vcc V  
Control Input Voltage Low   0   0.8 V  
Link Distance with G.652 D 0.002   10 Km 2

Diagnostics Monitoring

Parameter Symbol Accuracy Unit Notes
Temperature monitor absolute error DMI_Temp ± 3 °C Over operating temperature range
Supply voltage monitor absolute error DMI_VCC ± 0.1 V Over full operating range
RX power monitor absolute error DMI_RX_Ch ± 2 dB 1
Bias Current Monitor DMI_Ibias_Ch ± 10% mA  
TX power monitor absolute error DMI_TX_Ch ± 2 dB 1

Transmitter Electro-optical Characteristics (Each Lane)

Parameter Test Point Min Typ. Max Units Notes
Power Consumption       4.5 W  
Supply Current Icc     1.21 A  
Overload Differential Voltage pk-pk TP1a 900     mV  
Common Mode Voltage (Vcm) TP1 -350   2850 mV 1
Differential Termination Resistance Mismatch TP1     10 % At 1MHz
Differential Return Loss (SDD11) TP1 See CEI-28G- VSR Equation 13-19 dB
Common Mode to Differential conversion and Differential to Common Mode conversion (SDC11, SCD11)   TP1     See CEI-28G-VSR Equation 13-20   dB
Stressed Input Test TP1a See CEI- 28G-VSR Section 13.3.11.2.1
Center Wavelength λt 1304.5   1317.5 nm  
Side Mode Suppression Ratio SMSR 30     dB  
Average Launch Power PAVG -2.4   4.5 dBm 3
Outer Optical Modulation Amplitude (OMAouter) POMA 0.7 4.7 4.2 dBm 4
Launch Power in OMA minus TDECQ For ER ≥4.5dB For ER <4.5dB   -0.7     dBm  
-0.6      
Transmitter and Dispersion Eye TDECQ     3.4 dB  
Cloure for PAM4 (TDECQ)            
TDECQ-10*log10 (Ceq)       3.4 dB 5
Extinction Ratio ER 3.5     dB  
RIN17.1 OMA RIN     -136 dB/Hz  
Optical Return Loss Tolerance TOL     15.6 dB  
Transmitter Reflectance RT     -26 dB  
Transmitter Transition Time       17 ps  
Average Launch Power OFF Transmitter, each Lane Poff     -15 dBm  

Electrical Characteristics

Parameter Test Point Min Typ. Max Units Notes
Differential Voltage, pk-pk TP4     900 mV  
Common Mode Voltage (Vcm) TP4 -350   2850 mV 1
Common Mode Noise, RMS TP4     17.5 mV  
Differential Termination Resistance Mismatch TP4     10 % At 1MHZ
Differential Return Loss (SDD22) TP4 See CEI-28G-VSR Equation 13-19 dB
Common Mode to Differential Conversion and Differential to Common Mode Conversion (SDC22, SCD22)   TP4     See CEI-28G-VSR Equation 13-21
Transition Time, 20% to 80% TP4 9.5     ps  
Common Mode Return Loss (SCC22) TP4     -2 dB 2
Vertical Eye Closure (VEC) TP4     5.5 dB  
Eye Width at 10-15 probability (EW15) TP4 0.57     UI  
Eye Height at 10-15 probability (EH15) TP4 228     mV  
Center Wavelength Λr 1304.5   1317.5 nm  
Damage Threshold THd 5.5     dBm 6
Average Receive Power   -7.7   4.5 dBm 7
Receive Power (OMAouter)       4.7 dBm  
Receiver Sensitivity (OMAouter) SEN     Equation (1) dBm 8
Stressed Receiver Sensitivity (OMAouter) SRS     -4.1 dBm 9
Receiver Reflectance RR     -26 dB  
LOS Assert LOSA -15     dBm  
LOS Deassert LOSD     -10.7 dBm  
LOS Hysteresis LOSH 0.5     dB  
Conditions of Stress Receiver Sensitivity Test
Stressed Eye Clousre for PAM4 (SECQ)     3.4   dB 10
SECQ-10*log10(Ceq)       3.4 dB 10

Pin Descriptions

PIN Logic Symbol Name/Description Note
1   GND Ground 1
2 CML-I Tx2n Transmitter Inverted Data Input  
3 CML-I Tx2p Transmitter Non-Inverted Data output  
4   GND Ground 1
5 CML-I Tx4n Transmitter inverted Data Input  
6 CML-I Tx4p Transmitter Non-Inverted Data output  
7   GND Ground 1
8 LVTLL-I ModSeIL Module Select  
9 LVTLL-I ResetL Module Reset  
10   VccRx +3.3V Power Supply Receiver 2
11 LVCMOS-I/O SCL 2-Wire Serial Interface Clock  
12 LVCMOS-I/O SDA 2-Wire Serial Interface Data  
13   GND Ground  
14 CML-O Rx3p Receiver Non-Inverted Data output  
15 CML-O Rx3n Receiver Inverted Data output  
16   GND Ground 1
17 CML-O Rx1p Receiver Non-Inverted Data Output  
18 CML-O Rx1n Receiver Inverted Data Output  
19   GND Ground 1
20   GND Ground 1
21 CML-O Rx2n Receiver Inverted Data output  
22 CML-O Rx2p Receiver Non-Inverted Data output  
23   GND Ground 1
24 CML-O Rx4n Receiver Inverted Data output 1
25 CML-O Rx4p Receiver Non-Inverted Data output  
26   GND Ground 1
27 LVTTL-O ModPrsL Module Present  
28 LVTTL-O IntL Interrupt  
29   VccTx +3.3V Power Supply transmitter 2
30   Vcc1 +3.3V Power Supply 2
31 LVTTL-I LPMode Low Power Mode  
32   GND Ground 1
33 CML-I Tx3p Transmitter Non-Inverted Data Input  
34 CML-I Tx3n Transmitter Inverted Data Output  
35   GND Ground 1
36 CML-I Tx1p Transmitter Non-Inverted Data Input  
37 CML-I Tx1n Transmitter Inverted Data Output  
38   GND Ground 1

Ordering Information

Model Number Part Number Voltage Temperature
AQSFP28-100G-LR1 OPCW-S10-13-CB1 3.3V 0°C to 70 °C
download brochure
Scroll to Top