Alpha Bridge SFP AQSFP28-100G-SR4
Features
- QSFP28 MSA compliant
- Compliant to IEEE 802.3bm 100GBASE-SR4
- Four independent full-duplex channels
- Supports 103.1Gb/s aggregate bit rate
- Up to 100m OM4 MMF transmission
- Operating case temperature: 0 to 70℃
- Single 3.3V power supply
- 4x25G electrical interface (OIF CEI-28G-VSR)
- Maximum power consumption 2.5W
- MTP/MPO optical connector
- RoHS-6 compliant
Applications
- Rack to Rack.
- Data Center.
- InfiniBand QDR, DDR and SDR.
- 100G Ethernet.
Absolute Maximum Ratings
Parameter | Symbol | Min. | Max. | Units | Note |
Storage Temperature | Ts | -40 | 85 | ℃ | |
Operating Case Temperature | Top | 0 | 70 | ℃ | |
Power Supply Voltage | Vcc | -0.5 | 3.6 | V | |
Relative Humidity (non-condensation) | RH | 0 | 85 | % | |
Damage Threshold, each Lane | THd | 3.4 | dBm |
Recommended Operating Conditions
Parameter | Symbol | Min. | Typ. | Max. | Units | Note |
Operating Temperature | Top | 0 | 70 | ℃ | ||
Power Supply Voltage | Vcc | 3.135 | 3.3 | 3.465 | V | |
Data Rate, each Lane | 25.78125 | Gb/s | ||||
Data Rate Accuracy | -100 | 100 | ppm | |||
Pre-FEC Bit Error Ratio | 5x10-5 | |||||
Post-FEC Bit Error Ratio | 1x10-12 | 1 | ||||
Control Input Voltage High | 2 | Vcc | V | |||
Control Input Voltage Low | 0 | 0.8 | V | |||
Link Distance (OM3 MMF) | D1 | 70 | m | |||
Link Distance (OM4 MMF) | D2 | 100 | m |
Transmitter Electro-optical Characteristics
Parameter | Symbol | Min. | Typ. | Max. | Units | Note |
Power Consumption | Icc | 2.5 | W | |||
Supply Current | TP1a | 757 | mA | |||
Overload Differential Voltage pk-pk | TP1 | 900 | mV | |||
Common Mode Voltage (Vcm) | TP1 | 350 | 2850 | mV | 1 | |
Differential Termination Resistance Mismatch | TP1 | 10 | % | At 1MHz | ||
Differential Return Loss (SDD11) | TP1 | See CEI-28G-VSR Equation 13-19 | ||||
Common Mode to Differential conversion and Differential to Common Mode conversion (SDC11, SCD11) | See CEI-28G-VSR Equation 13-20 | dB | ||||
Stressed Input Test | See CEI-28G-VSR Section 13.3.11.2.1 | |||||
Center Wavelength | λc | 840 | 850 | 860 | nm | |
RMS Spectral Width | △λrms | 0.6 | nm | |||
Average Launch Power, each Lane | PAVG | -8.4 | 2.4 | dBm | ||
Optical Modulation Amplitude | POMA | -6.4 | 3 | dBm | 2 | |
Launch Power in OMA minus | -7.3 | dBm | ||||
TDEC, each Lane | ||||||
Transmitter and Dispersion Eye | 4.3 | dB | ||||
Closure (TDEC), each Lane | ||||||
Extinction Ratio | ER | |||||
Optical Return Loss Tolerance | TOL | 12 | dB | |||
Average Launch Power OFF | Poff | -30 | dBm | |||
Encircled Flux | ≧86% at 19μm ≦30% at 4.5μm | |||||
Transmitter Eye Mask Definition {X1, X2, X3, Y1, Y2, Y3} | {0.3, 0.38, 0.45, 0.35, 0.41, 0.5} | 3 |
Receiver Electro-optical Characteristics
Parameter | Test Point | Min | Typ. | Max | Units | Notes |
Differential Voltage, pk-pk | TP4 | 900 | mV | |||
Common Mode Voltage (Vcm) | TP4 | -350 | 2850 | mV | 1 | |
Common Mode Noise, RMS | TP4 | 17.5 | mV | |||
Differential Termination Resistance | TP4 | 10 | % | At 1MHz | ||
Mismatch | ||||||
Differential Return Loss (SDD22) | TP4 | See CEI-28G-VSR Equation 13-19 | ||||
Common Mode to Differential conversion and Differential to Common Mode conversion (SDC22, SCD22) | TP4 | See CEI-28G-VSR Equation 13-20 | dB | |||
Common Mode Return Loss (SCC22) | TP4 | -2 | dB | 2 | ||
Transition Time, 20 to 80% | TP4 | 9.5 | ps | |||
Vertical Eye Closure (VEC) | TP4 | 5.5 | dB | |||
Eye Width at 10-15 probability (EW15) | TP4 | 0.57 | UI | |||
Eye Width at 10-15 probability (EW15) | TP4 | 228 | mV | |||
Center Wavelength | λc | 840 | 850 | 860 | Nm | |
Damage Threshold, each Lane | THd | 3.4 | dBm | 3 | ||
Average Receive Power, each Lane | -10.3 | 2.4 | dBm | |||
Receive Power (OMA), each Lane | 3 | dBm | ||||
Receiver Sensitivity (OMA), each Lane | SEN | -9.2 | dBm | For BER=5x10-5 | ||
Stressed Receiver Sensitivity "(OMA), each Lane" | -5.2 | dBm | 4 | |||
Receiver Reflectance | RR | -12 | dB | |||
LOS Assert | LOSA | -30 | dBm | |||
LOS Deassert | LOSD | -12 | dBm | |||
LOS Hysteresis | LOSH | 0.5 | dB | |||
Conditions of Stress Receiver Sensitivity Test (Note 3) | ||||||
Vertical Eye Closure Penalty, each Lane | 1.9 | dB | ||||
Stressed Eye J2 Jitter, each Lane | 0.3 | UI | ||||
Stressed Eye J9 Jitter, each Lane | 0.47 | UI | ||||
OMA of each aggressor lane | 0.4 | dBm |
Pin Descriptions
PIN | Logic | Symbol | Name/Description | Note |
1 | GND | Ground | 1 | |
2 | CML-I | Tx2n | Transmitter Inverted Data Input | |
3 | CML-I | Tx2p | Transmitter Non-Inverted Data output | |
4 | GND | Ground | 1 | |
5 | CML-I | Tx4n | Transmitter inverted Data Input | |
6 | CML-I | Tx4p | Transmitter Non-Inverted Data output | |
7 | GND | Ground | 1 | |
8 | LVTLL-I | ModSeIL | Module Select | |
9 | LVTLL-I | ResetL | Module Reset | |
10 | VccRx | +3.3V Power Supply Receiver | 2 | |
11 | LVCMOS-I/O | SCL | 2-Wire Serial Interface Clock | |
12 | LVCMOS-I/O | SDA | 2-Wire Serial Interface Data | |
13 | GNC | Ground | ||
14 | CML-O | Rx3p | Receiver Non-Inverted Data output | |
15 | CML-O | Rx3n | Receiver Inverted Data output | |
16 | GND | Ground | 1 | |
17 | CML-O | Rx1p | Receiver Non-Inverted Data Output | |
18 | CML-O | Rx1n | Receiver Inverted Data Output | |
19 | GND | Ground | 1 | |
20 | GND | Ground | 1 | |
21 | CML-O | Rx2n | Receiver Inverted Data output | |
22 | CML-O | Rx2p | Receiver Non-Inverted Data output | |
23 | GND | Ground | 1 | |
24 | CML-O | Rx4n | Receiver Inverted Data output | |
25 | CML-O | Rx4p | Receiver Non-Inverted Data output | |
26 | GND | Ground | 1 | |
27 | LVTTL-O | ModPrsL | Module Present | |
28 | LVTTL-O | IntL | Interrupt | |
29 | VccTx | +3.3V Power Supply transmitter | ||
30 | Vcc1 | +3.3V Power Supply | ||
31 | LVTTL-I | LPMode | Low Power Mode | |
32 | GND | Ground | 1 | |
33 | CML-I | Tx3p | Transmitter Non-Inverted Data Input | |
34 | CML-I | Tx3n | Transmitter Inverted Data Output | |
35 | GND | Ground | 1 | |
36 | CML-I | Tx1p | Transmitter Non-Inverted Data Input | |
37 | CML-I | Tx1n | Transmitter Inverted Data Output | |
38 | GND | Ground | 1 |
Ordering information
Model Number | Part Number | Voltage | Temperature |
AQSFP-100G-SR | OPCW-MX1-85-CB | 3.3V | 0°C to 70 °C |